Need help?Do you have a question about the Colorlight Z6 Super Controller and is the answer not in the manual?
General| Brand | Colorlight |
|---|---|
| Model | Z6 Super Controller |
| Category | Controller |
| Language | English |
Details the front panel controls, including LCD, knob, and function/selection keys.
Details the rear panel connections for input, output, and controlling interfaces.
Illustrates how the Z6 controller connects to external devices like routers, cameras, PCs, and displays.
Guide to downloading and installing the LEDVISION software, including language selection and component installation.
Instructions to run LEDVISION software to detect connected senders and receiving cards for system configuration.
Settings for configuring the LED screen parameters.
Configure input sources, scaling, clipping, PIP, control area, EDID, network, Art-Net, and 3D settings for the sender device.
Configure basic and intelligent settings for individual LED screen cabinets, including module info, performance, and advanced parameters.
Set up receiving card quantities and connection lines, then send and save parameters to the receiving cards.
Guide to using the controller's knob and buttons (OK, ESC) for menu navigation and parameter adjustment.
Overview of the controller's main LCD display, showing signal status, network connectivity, and system information.
Adjust display parameters like brightness, color temperature, black screen, and test modes.
Configure EDID settings for HDMI or DVI inputs, including resolution, width, height, and frame rate.
Configure splicing for DVI inputs, setting width and height of splicing units for multi-screen display.
Set clipping parameters (X, Y, width, height) for input signals like HDMI, DVI, SDI to crop the video.
Configure output parameters for Main and PIP (Picture-in-Picture) modes, adjusting position and size.
Adjust the output image position by 'Whole' or 'By Port' for precise screen alignment.
Enable 'Lock to Input' for synchronized video display when multiple controllers are cascaded.
Configure Art-Net settings for intelligent dimming, adjusting brightness, RGB, and color temperature channels.
Configure network settings, including IP address, subnet mask, gateway, and DHCP options.
Select the display language for the controller interface (English or Chinese).
Manage system settings such as date, time, restoring factory defaults, and checking firmware information.
To Next Page
