4
② After selecting a language, an installation wizard like below will appear, click [Next];
Then choose installation location, click [Browse] to change default target location, then click
[Next] after completing;
Choose components according to your own computer status, click [Install] to complete;
After the installation is complete you are ready to use LEDVISION.
5 Pa
rameter Configuration
Please make sure the correctness of the hardware connection before setting, use LEDVISION
to detect sender and all receiving cards.
5.1 Detect Sender and Receiving Card
① Run LEDVISION, click [Control] – [Screen Control], [Select Sending Device] for [Sender].
To Next Page
Loading...
