Colorlight Z6 Super Controller - Output Setting; Output Shift

20
Enter the clip interface of “HDMI” or “DVI×4” or “SDI1” or “SDI2”, press the knob/OK to turn
on/off clip. Set X, Y, width and height of input signal by knob then save the data.
6.3.5 Output Setting
Rotate the knob to select output setting, then press the knob/OK to enter submenu of
“Output Setting”; Continue rotating the knob to select “Main” or “PIP1” or “PIP2”, press the
knob/OK to enter the output setting interface. Rotate the knob to adjust X, Y, width and height of
output, then save it.
6.3.6 Output Shift
Rotate the knob to select output shift, then press the knob/OK to enter submenu of “Output
Shift”.