6
5.2.1 Sending Device Setting
[Select Sending Device] for [Sender], and detect senders. Sending Device Setting includes 8
parts: Output, Control Area, EDID, Network, Art-Net, 3D, Other, Detect Receivers.
1, Output
① Signal Source
When the input signal source of Z6 is normal, the upper right of the software interface will
display the input signal information auto acquired via the software. At the moment, users can
select signal source (HDMI/DVI/SDI1/SDI2) according to needs in [Main]; if PIP has been open,
users can also select specific signal source (HDMI/DVI/SDI/SDI2) in [PIP]. Note: Main and PIP can’t
select the same source.
To Next Page
Loading...
