Colorlight Z6 Super Controller - Network Setting; Language Setting; System Setting

22
brightness, RGB, color temperature and test mode in “Channel Setting”, set up the minimum value
and the maximum value of it; users can also conduct Net setting, Sub-Net setting and Universe in
“Port Address”.
6.3.9 Others
Network Setting: Users can automatically obtain an IP address or set manually. Enter the
setting of “Network Setting”, press the knob/OK to turn on/off DHCP; or press the knob/OK to
enter manual IP setting, you can set up IP address, subnet mask and gateway respectively via the
knob.
Language: Enter the setting interface of “Language”, press the knob/OK to switch the
language.
System Setting: In “System Setting”, users can set date and time, restore factory settings and
check current firmware information.