Colorlight X4e - User Manual

Need help?

Do you have a question about the Colorlight X4e and is the answer not in the manual?

Summary

1. Overview

2. Appearance

Front Panel

Describes the components visible on the front panel of the X4e controller.

Back Panel

Details the rear panel of the X4e controller, outlining all connection interfaces.

3. Signal Connection

4. LEDVISION Installation

5. Parameter Configuration

5.1 Detect Sender and Receiving Card

Instructions for using LEDVISION to detect connected senders and receiving cards on the network.

5.2 LED Screen Setting

Steps to access and configure LED screen settings, including sending device, screen parameters, and receiver mapping.

5.2.1 Sending Device Setting

Configuration of the sender device, covering source setup, control area, EDID, and other parameters.

5.2.2 Screen Parameters Setting

Configuring specific display parameters for individual LED cabinets.

5.2.3 Receiver Mapping Setting

Mapping the physical arrangement of receiving cards to the controller's output ports.

6. LCD Operation Instruction

6.1 Operational Motion Instruction

How to navigate menus and adjust settings using the knob and ESC button.

6.2 Main Interface

Overview of the information displayed on the X4e's main LCD screen.

6.3 Operation Instruction

Listing the main menu options accessible through the LCD interface.

6.3.1 Display Setting

Adjusting display properties such as brightness, color temperature, and gray level.

6.3.2 EDID Setting

Configuring EDID for input sources to match display resolutions.

6.3.3 Cropping Setting

Cropping specific input signal areas by adjusting coordinates and dimensions.

6.3.4 Output Setting

Configuring output image parameters for main and PIP displays.

6.3.5 Preset Setting

Managing and applying saved configuration presets for display settings.

6.3.6 Output Shift

Adjusting the positional offset of the output image, either globally or per port.

6.3.7 Tile Mapping

Configuring complex display layouts by mapping tiles and setting cabinet parameters.

6.3.8 Lock To Input

Synchronizing video display across multiple cascaded controllers using Genlock.

6.3.9 Language Setting

Changing the user interface language.

6.3.10 System Setting

Performing factory resets and checking system firmware information.