www.colorlightinside.com
7
5. Parameter Configuration
Please make sure the correctness of the hardware connection before setting, use
LEDVISION to detect sender and all receiving cards.
5.1 Detect Sender and Receiving Card
1. Run LEDVISION, click [Control]—[Device Information] to enter the Device Information
window.
2. Click [Detect Senders] in [Sender]. Please check the hardware connection or the
installation of relevant driver if cannot detect senders.
Select network port and click [Detect Receiver Cards] respectively, the software will
automatically acquire the receiver card quantity of each network port of the sender. Please
check corresponding cable if the numbers of receiver card are inconsistent with actual
status.
To Next Page
Loading...
