• Using Teflon tape or pipe sealant, attach the female quick-connect fitting to the pressure-regulated
source of air (compressed air bottle shown). Use a 9/16in open-end crescent wrench to fully tighten.
• Join the other end of the 6m (20ft) air-supply line to the quick-connect fitting.
• Connect the 2-circuit valve power cable between the “Valve Power” port of the Treadmill Controller
and the 2-position Molex Mini-Fit Jr jack on the Exer 3/6 Treadmill. Be sure the locking lever snaps
down to secure the cable to the ports.
This completes the assembly of the Air-Puff Stimulus.
WARNING!!! Do not pressurize the air puff system beyond 2069mmHg
possible damage may result to connector fittings and equipment.
To Next Page
Loading...
