39
PERFORMANCE
1. Carry out the operations for the preparation of the machine
2.
Connect the connector to the batteries (1)
3.
Check that the parking brake is released (2)
4.
Turn the key of the general switch (3) clockwise of a quarter turn. Immediately, the
general green signal lamp comes on (4) and the digital display indicates the charge
level of the batteries
2
3
4
ON/OFF
5. Press the brushes motor switch (1)
6.
Press the suction motor switch (2)
Note The machines with automatic version have the functioning of the suction motor
only during forward motion
7.
Press the solenoid valve switch (3) (only in the automatic versions)
8.
Adjust the amount of detergent solution through the cock lever (4).
3
2
1
4
9. Push forward and lift the control lever to lower the brushes base and to adjust its
pressure onto the floor (1). In case of machines with actuator, lower the lever button
(2) until the yellow lamp comes off (3).
10.
Lower the squeegee acting upon the lever (4).
Note For the automatic versions see further on in the paragraph “SQUEEGEE
AUTOMATIC MANUAL”
1
2
3
4
11. Pushing forward the lever on the handle bar, the machine begins to move. During the
first metres of operating, check that the brushes pressure is suitable (see further on
under “BRUSHES PRESSURE”), that the quantity of the detergent solution is
sufficient and that the squeegee dries perfectly.
The machine will now start working efficiently until the detergent solution runs out.
To Next Page
Loading...
