IGS-NT-BC, SW Version 1.2.0, ©ComAp – January 2019
IGS-NT-BC-1.2.0 Reference Guide.PDF
Code of the current power factor control mode. The description how to obtain the
text representation of each code can be found at the value Engine state.
Group: Gensets
Value: Gen-set1 pwr .. Gen-set31 pwr
Actual active power of particular gen-sets subordinated to the bank controller.
Bits of this value show "1" if the bank controller receives messages from the
subordinated gen-set controller which has address corresponding with the bit
position. Bit 0 represents address 1 etc. This value contains information about
controllers with addresses 1-16.
NOTE:
The bit which corresponds to the own controller is always set to "1".
Bits of this value show "1" if the bank controller receives messages from the
subordinated gen-set controller which has address corresponding with the bit
position. Bit 0 represents address 17 etc. This value contains information about
controllers with addresses 17-32.
NOTE:
The bit which corresponds to the own controller is always set to "1".
To Next Page
Loading...
