ComAp MainsPro - User Interface; Setpoint Change

MainsPro, SW version 1.4, ©ComAp – January 2013
MainsPro Installation and Operation Guide
1-13
User interface
Control and navigation Pushbuttons - basic operation
In the measurement screens, use the and arrow buttons to browse through the
measured values as displayed on the 4x20 alphanumerical display. See the chapter
Measurement screens to get the basic orientation.
To enter the setpoints menu, push the button. For setpoints change, see the following
chapter.
To enter the init screen, to reset operation time, perform factory default reset, reset statistics
or enter the Test mode, push the and at the same time. Together with the init screen
display, the unit performs lamp test by simultaneous cycling of all LEDs through all indication
colours.
For confirmation of any value change or query, use the button.
For leaving any value change or query screen without change, use button.
From any screen, press and hold the button for 2 seconds to return back to the main
measurement screen (homepage).
Setpoints change:
1. Push the button to open the setpoints menu.
2. By buttons and browse through the menu. The setpoint groups are displayed in the
cycling order, i.e. from the last setpoint group by button , the cursor moves to the first
group and vice versa.
4 x 20
Alpha-
numerical
display
Signalization
LEDs
TRIP LED
Fault Reset
button
3-phase
voltage
measurement
Frequency
measurement
Last trip
indication
Last trip
timer
Mechanical
sealing
indication
Mechanical
seal
Control and
navigation
pushbuttons