ComAp MainsPro - MainsPro Utilization Steps

MainsPro, SW version 1.4, ©ComAp – January 2013
MainsPro Application Guide
2-4
Important Steps of MainsPro utilization
This process describes a typical decisions and technical steps to follow in case of MainsPro utilization,
if required by the distribution network operator (DNO).
Does the DNO
require a mains-
protection unit? If
yes, then...
Request the
required protection
settings from the
DNO
Install MainsPro
according to the
MainsPro
Installation and
Operation Guide
Power-up
MainsPro
Disconnect the relay
output connectors to
avoid misoperation
of the connected
devices
Adjust setpoints
according to the DNO
requirement and your
site design
Power-down
MainsPro, connect all
terminal connectors
and power-up again
Provide witnessed
commissioning tests
and seal the unit if
required by the DNO
Energize your
generator and
synchronize!
For technical
support, contact us
at
support@comap.cz
Design MainsPro into
your site arrangement.
Use this MainsPro
Application and
Reference Guide for
detailed information