Combilift Ltd. C4000-C5000XL O&S Manual
4-8
C4000-OM-EN-08
Recommended Engine Oil Specification:
Diesel: API – CF (See notes at 4.12: if diesel particulate filter is fitted)
SAE 15W40 – All Temperatures
SAE 10W30 – All Temperatures
LPG: API – SJ/CF
SAE 10W30 – All Temperatures
SAE 15W40 – Above -18°C (0°F)
In order to change the Oil and oil filter, the following steps should be taken,
Extend the mast carriage forward
in order to gain access to the
engine oil filter and oil drain plug.
Position a suitable container
beneath the Oil drain plug as
indicated by the diagram opposite.
(Container must be capable of
holding 10.5 litres)
Remove the drain plug and allow
the system time to drain
completely
Once the system has drained
completely, dispose of the used oil
in a safe and responsible manner
Remove the engine oil filter located on the front of the engine as indicated
by the diagram above
Apply some engine oil to the new oil filter cartridge before fitting
Install the new engine oil filter cartridge, ensuring that the O-ring seal is
correctly placed. Only use a genuine Combilift component
Reinstall the drain plug and tighten appropriately
Note
Do not pour fluids into the ground, down a drain or into a stream, pond or
lake. Observe relevant environmental protection regulations when disposing
of oil
coolant
fuel
electrol
te and other harmful waste
Oil Filter
Drain
Plug
Bucket/
Container
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
