11
The Security Panel provides additional access to
your security system. You can use it to arm and
disarm your system and more. This manual also
shows you how to arm and disarm the system
with your Key Chain Remote.
02 //
SECURITY PANEL
Arm/Disarm
1. Press [DOORS+WINDOWS] to arm the sensors on
your doors and windows only.
2. Press [DOORS+WINDOWS] and then press [MOTIONS]
to set the system to Arm All, which also includes the
motion detectors.
3. To disarm the system, press [DISARM] on the panel
and enter your access code.
Arm with Bypass
You can arm your system even if a door or window
is open.
1. To arm the sensors on your doors and windows only,
press [DOORS+WINDOWS]. The system will display
a warning that a door or window is open. Press
[DOORS+WINDOWS] again to arm the system.
2. To Arm All, press [DOORS+WINDOWS] twice and
then press [MOTIONS].
Arm/Disarm with Key Chain Remote
1. Press the [lock symbol] button until a red LED
flashes once to arm Doors+Windows.
2. Press the [lock symbol] twice to set Arm All. The red
LED on the key chain remote should flash twice — once
for each push.
3. To disarm, press the [unlock symbol] button until
you see the red LED blink once.
4. If the alarm fails to disarm, go to the control panel
and press the [DISARM] button and enter your
access code. Or contact your Central Monitoring
Station as soon as possible.
12qUESTIONS? customer.comcast.com/homesecurity
To Next Page
Loading...
Need help?
General