COMECO RT1800 - Page 15

15
SEt6
0
/
1 for
SOFt
0
/
1 for
Unit
0
/
1 for
PVOS
0
/
1 for
SVOS
denies/grants access to parameters:
SVOS, PVOS, Unit, SOFt
↓ SET
SEt7
0
/
1 for
Hz
0
/
1 for
OPAd
0
/
1 for
OUd
0
/
1 for
CASC
denies/grants access to parameters:
CASC, OUd, OPAd, Hz
↓ SET
SEt8
0
do not
change
0
do not
change
0
do not
change
0
/
1 for
INVERT
sets transmit function in case of linear input
INVERT: 0 = direct (e.g. 4...20 mA → 0...100 °C);
1 = reverse (e.g. 4...20 mA → 100...0 °C)
0
do not
change
0
/
1 for
START
0
/
1 for
RESUME
0
/
1 for
REPEAT
defines controller operation in profile mode (if available)
REPAEAT: 0 = single execution of profile control program;
1 = set point profile program repeats cyclically
RESUME: 0 = program execution ceases at power dropout;
1 = program execution resumes at power restore
START: 0 = program starts from zero;
1 = program starts from currently measured value
↓ SET
SEt9
retransmission output function
0
/
1 for
RETRANSMIT
PV
0
/
1 for
RETRANSMIT
SV
0
/
1 for
TIME UNITS
X
do not
change
TIME UNITS: hh:mm(0) or mm:ss (1) - with pattern set point ONLY
RETRANSMIT SV: retransmits set point
RETRANSMIT PV: retransmits measured value
↓ SET
SEt0
0
/
1 for
REMOTE
SV
X
do not
change
REMOTE SV = 1 : set point is received from the second
input and is no longer set through keyboard
X: for RT1800-S, X = 0; for the rest of the cases, X = 1
these values determine standard PID control
↓ SET
inP2
second input
0 = none
↓ SET
OUtY
number of control outputs
0 = one, 1 = two fewer than the physically mounted control outputs may be set
↓ SET
over again