Commodore 64C - Loading and Running Software Procedures

how to load and run software
To use a software package, you must do two things:
—FIRST, you must place the software program in your Commodore 64C's
memory. This is called loading the program. In some cases, you load the program
by using the LOAD command, as explained on pages 26, 27, and 28. In other
cases, the program is loaded automatically.
—SECOND, you must tell the computer to carry out the program's instruc
tions. This is called running the program. In some cases, you run the program by
using the RUN command. In other cases, the program not only loads but also
runs automatically.
The following pages tell you how to LOAD and RUN disk, cartridge and tape
software.