Commodore AMIGA 1084S - FCC Users Manual Statement

Monitor 1084S GB-1
Copyright © 1991 by Commodore Electronics Limited. All Rights Reserved, This document may not, in
whole or in part, be copied, photocopied, reproduced, translated or reduced to any electronic medium or
machine readable form, with out prior consent, in writing, from Commodore Electronics Limited.
With this document, Commodore makes no warranties or representations, either express, or implied,
respect to the products described herein. The information presented herein, is being supplied on
an “AS IS” basis and is expressly subject to change without notice. IN NO EVENT WILL COMMODORE
BE LJABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES RE
SULTING FROM ANY CLAIM ARISING OUT OF THE INFORMATION PRESENTED HEREIN, EVEN
IF IT HAS BEEN ADVISED OF THE POSSIBILITIES OF SUCH DAMAGES. SOME STATES DO NOT
ALLOW THE LIMITATION OF SUCH IMPLIED WARRANTIES OR DAMAGES. SO THE ABOVE LIMI
TATIONS MAY NOT APPLY
Commodore and the Commodore logo are registered trademarks of Commodore Electronics Limited in
the USA and in many other countries. Amiga is a registered trademark of Commodore-Amiga, Inc. in the
USA and in many other countries.
FCC USER'S MANUAL STATEMENT
WARNING: This device complies with Part 15 of the FCC Rules and with Standard C108.8-M1983 of
the Canadian Standards Association's Regulations. Operation is subject to two conditions: (1) This de-
vice may not cause harmful interference, and (2) This device must accept any interterence received, in-
cluding interference that may cause undesired operation. If you suspect this device is causing inter-
ference, you can test this device by turning it off and on. If this device does cause interference, correct it
by doing any of the following:
e Reorientthe receiving antenna or AC plug.
‘© Change the relative positions of the computer and the receiver.
e Plug the computer into a different outlet so the computer and receiver are on different circuits.
CAUTION: Only equipment with shield-grounded cables (computer input-outlet devices, terminals, prin-
ters, etc), certified to comply with Class B limits, can be attached to this device.
Operation with non-certiied peripherals may result in communications interference. Changes or modifica-
tions to this device not expressly approved by the party responsible for compliance could void users auth-
ority to operate the device.
Your house AC wall receptacle must be a three-pronged type (AC ground). If it is not, contact an electri-
cian to install the proper receptacle, If a multi-connector box is used to connect the computer and pe-
ripherals to AC, the ground must be common to all units.