Commodore PC 10 - Page 379

[
[~
l=
[~
Debug Error Messages
During a debug session, you may receive any of the following
error messages. Each error ends the debug command under
which it occurred, but does not end debug itself.
Error
code
BF
BP
BR
DF
Definition
Bad flag
You
attempted to change a flag, but the characters
you typed were not one of the acceptable pairs of
flag values. See the R (register) command for the list
of acceptable flag entries.
Too many breakpoints
You specified
more than ten breakpoints as param-
eters to the G (go) command. Retype the G com-
mand using
ten or fewer breakpoints.
Bad register
While using
the R command you typed an invalid
register name. See
the R command for the list of
valid register names.
Double flag
You
typed two values for one flag. You may specify
a flag value only
once per RF command.
Debug 2411
Debug error codes