Commodore PC 10 - Page 385

[-
Appendix B How to Configure Your System 247
Break
Purpose:
Sets CONTROL-C check.
Syntax:
break = [ON]
or
break = [OFF]
Comments:
Depending on the program you are running, you may use
CONTROL-C to stop an activity (for example, to stopsorting a file).
Normally,
MS-DOS checks to see whether you have pressed
CONTROL-C only while it is reading from the keyboard or writing
to the screen or printer_ Therefore, setting break to ON extends
CONTROL-C checking to other functions, such as disk reading and
writing_
Example:
To turn off CONTROL-C checking, put the following line in your
conJig_sys file:
Break
Setting and canceling
CONTROL-C checking
~ break=off
c
\
)