Commodore PC 10 - Page 423

)
File filename canceled by operator
[Print)
• MS-DOS displays this message when you specify the /t switch
with the Print command.
File cannot be converted
[Exe2bin)
• The input file is not in the correct format.
File cannot be copied onto itself
[ Copy ][ Replace ][ Xcopy )
• The source filename you specified is the sf:lme as the target
filename_
File creation error
[ MS-DOS ][ Edlin ][ Restore ][Xcopy ]
• You tried to add a new filename or replace a file that already
exists
in the directory, or there was not enough space for the
file-
If the file already exists, it is a read-only file and cannot
be replaced. This error message may also occur if the root
directory is fun out of files, or if the filename is the same as
a volume or directory, or a hidden (or system) file.
File is READ-ONLY
[Edlin]
• The file is designated read-only, so you may not change it.
File name must be specified
[Edlin]
• You did not specify a filename when you started Edlin
You should type the edlin command followed by a filename_
File not found
[Chkdsk ][Edlin][ FC][ Find ][Print][ Recover ][Rename ][Xcopy]
• MS-DOS could not find the file that you specified, or you tried
to
rename a file with a name already in the directory_
Check to see that you entered the filename correctly_
File not in PRINT queue
[Print)
• The file that you specified was not in the print queue, so you
cannot remove it from the queue.
Check to see that you entered the filename correctly_
E-F28S!