First cluster number
is
invalid,
entry truncated .
[Chkdsk]
• The
file
directory entry contains
an
invalid
pointer
to the data
area
If
you
specified the
If
switch, tbe
file
is truncated to a
zero-length file.
FIRST
diskette bad
or
incompatible
[Diskcomp]
• Diskcomp
cannot
recognize the
format
on
the source disk.
You should run
~dsk
to
help you identify the problem.
Fixups needed - base segment hex:
[Exe2bin]
• The source (.exe)
file
contained
information
indicating that a
load
segment
is
required
for
the file.
You must specify
the
absolute segment address
where
the
fin-
ished module
is
to
be
located.
For cannot
be
nested
[MS-DOS]
• You
cannot
nest For
commands
in
a batch file.
Format another (YIN)?
[Format]
• Format displays tbis message when
it
has
finished
formatting
a disk.
Type Y (for Yes)
if
you want
to
format another disk,
or
type N
(for No)
if
you don't.
If
you accidentally type Y, you
can
abort
the format process
by
typing CONTROL-C in response
to
the
mes-
sage "Strike any key."
Format complete
[Format]
• Format displays· this message when
it
has finished
formatting
the .disk in the specified drive.
Format failure
[Format]
• MS-DOS could
not
format
the disk. This message is
usually
displayed
with
an
explanation
as
to
why
the
command
failed.
Format not supported on drive x:
[Format]
• You
cannot
use Format to
format
this drive.
You may have specified device parameters that your
computer
cannot support.
F2871
To Next Page
Loading...
