Incorrect DOS Version
[Append][ Attrib ][Backup][ Chkdsk ][Diskcomp][ Diskcopy]
[Edlin][
FC][
Find ][Format
][
Graphics JUoin
][
Keybxx]
[Label][ Mode
][
More
][
Print
][
Recover
][
Replace
][
Restore]
[Share
][
Sort
][
Subst
][
Sys
][
Tree
][Xcopy ]
•
Some
MS-DOS utilities
will
not
run
on
older versions
of
the
operating system,
and
many
are
written
to
run
only
on
the
exact
version
of
MS-DOS
that
they were created for.
You must use
the
correct
version
of
MS-DOS
to
run this
command.
Incorrect number of parameters
[Join][Subst]
•
You
specified either too
many
or
too
few
options
in
the
command
line.
Incorrect parameter
[Assign
][
Share]
• One
of
the
options
you
specified is wrong.
Infinite retry on parallel printer timeout
[Mode]
•
Your
printer
is
probably
off-line
or
not
ready.
If
the
printer
appears
to
be
ready,
you
may have to press
the
CONTROL-ALT-DEL keys
to
reset
the
computer.
Insert backup diskette n into drive x:
[Backup
][
Restore]
• This message
prompts
you
for
the
nth
backup
disk
Put
the
next
disk into
the
specified drive. Be sure
to
label
each
backup disk in the appropriate
order
for use
when
restoring
the
files.
Insert destination disk
in
drive
x:
and strike any key when ready
[Sys]
• This message appears
when
you
are
using
Sys to transfer the
operating system
with
a single
disk
drive.
You should insert a disk in
the
appropriate drive and press any
character
or
number
key
to
begin processing.
Insert diskette for drive
x:
and strike any key when ready
[MS.DOS]
• This message appears
when
MS·DOS is copying
and
formatting.
You should insert a disk in
the
appropriate drive
and
press any
character
or
number
key
to
begin processing.
F-/2891
To Next Page
Loading...
