No room in directory for file
[Edlin]
• You tried to create or save a file to the root directory,
but
it
is
either
fun
or
you
specified
an
invalid disk drive or filename.
Check
the
command line
that
you used
to
start
edlin
for an
invalid filename
or
disk drive entry. If your command contains
no
invalid entries, you should
run
the
chkdsk
program for
the
specified disk drive.
If
the status
report
shows that
the
disk
directory is full, and
if
there
is still enough memory left
on
the
disk,
you
may
be
able
to
create
the
file in a subdirectory. (This
is because subdirectories are
not
limited in size as is
the
root
directory.) Otherwise, remove
the
disk and replace it
with
another formatted disk.
No
room in root directory
[Label]
•
There
is
not
enough room
in
the root directory
for
a volume
label
Delete
or
move some
of
the
files from
the
root
directory
to
make room for the volume label.
No
space left on device
[Backup ][FC)[Restore]
• You cannot back up or restore
any
more files,
and
you
cannot
send
any
more output from a file comparison to
your
disk
because the target disk is
now
full
You should probably delete some
of
the
files
on
the
disk
to
make
more
room.
No
sub-directories exist
[Tree]
• You have specified the
/s
switch,
but
the directory does
not
contain subdirectories.
No
such file
or
directory
[Backup ][FC][Restore]
• One
or
more
of
the files
or
directories that
you
specified does
not
exist.
***
Not able
to
back up (or restore) file
***
[Backup]
• This message may occur
if
there was
an
error
in
the source file
or
on
the target disk.
Use
the
chkdsk
command
on
the
source disk
to
see
if
you can
determine
the
problem.
N299/
To Next Page
Loading...
