[
[~
c
Parameters not compatible with fixed disk
[Format]
• You have used a switch that is
not
compatible with the speci-
fied drive.
Parameters· not supported
[MS-DOS][ Format]
• You have specified parameters that MS-DOS does
not
support.
Parameters not supported by Drive
[Format]
• Format displays this message when the device driver
for
this
drive does
not
support Generic
IOCTL
function requests.
Path(name) too long
[Print ][Replace ][Xcopy]
• The pathname
you
specified was too
long.
You may have
to
change directories
to
use this command
with
files in
deep
subdirectories_
Path not found
[ Chkdsk ][Replace
][
Subst ][Xcopy ]
• You specified
an
invalid pathname.
Press any key
to
begin adding (replacing) file(s)
[Replace]
• When
you
specify the
Iw
switch, Replace displays this message
to
prompt
you
to start replacing files.
Press any key
to
begin formatting x:
[Format]
• This
prompt
is issued before
you
format a disk.
Press any key
to
begin
the
format process. Or,
if
you wish
to
end
this command, press CONTROL-C.
Press any key
to
begin recovery
of
the
n file(s) on drive x:
[Recover]
• This
prompt
is issued before
you
recover a disk
or
file.
Press any key
to
begin
the
recovery. Recovered files are named
filennnn.rec. If you wish
to
end
this command, press CONTROL-C.
Press any key when ready
•••
[Diskcomp ][Diskcopy]
• This prompt gives
you
time to insert the appropriate disks
before copying them
When you have inserted
the
disks into the appropriate drives,
press any key
to
begin
the
diskcopy
process. Or,
if
you wish
to
end
this command, press CONTROL-C.
N-P3011
To Next Page
Loading...
