Target diskette may be unusable
[Diskcopy)
• Either the target disk has
an
unrecognizable format, or
it
is
bad.
Try
to
format
the
disk
with
the
format command,
or
run
chkdsk
on
it
to
determine
the
problem.
Target is a floppy (or hard) disk
[Backup)
• This is
an
informational message only.
Target is full
[Restore)
•
There
is
no
more room
on
the target disk
for
restored files.
You must delete some
of
the
files
on
the
disk
to
make room for
these files,
or
use another disk.
Target is Non-Removable
[Restore)
• This is
an
informational message only.
Terminate batch job (YIN)?
[MS·DOS)
•
If
you
press CONTROL·C while in batch mode, MS·DOS asks
you
whether or
not
you
wish to
end
batch processing.
Press
Y.
(for Yes)
to
end
processing,
or
N (for
No)
to
continue.
The last file was not restored
[Restore)
•
There
was
not
enough room
on
the target disk
for
the file, or
the last file was
bad.
Use
the
chkdsk command
to
determine
the
problem.
Too
many files open
[Edlin)[Label)
• MS·DOS could
not
open the .bak file or write the volume label
due to the lack
of
available system file handles.
Increase the value
of
the
rues
command in
the
config.sys file.
Too many open files
[Backup)[
FC)[
Restore
)[
Xcopy )
• MS·DOS could
not
open the files that
you
want
to compare due
to the lack
of
available system file handles.
Increase
the
value
of
the files command in the config.sys file.
S-T3071
To Next Page
Loading...
