Ethernet or wireless?
There are two ways to connect your computer (or other equipment) to the Data Gateway.
Ethernet
Ethernet is a standard method of connecng two or more computers into a Local Area
Network (LAN). You can use the Ethernet connecon if your computer has built-in Ethernet
hardware.
Ethernet connecons are slightly more secure than wireless connecons, making it harder
for unauthorized users to “eavesdrop” on communicaons between the router and the
connected device. However, Ethernet connecons are not as convenient or easy to install as
wireless connecons.
Note: To connect more than two computers to the DG6450 through the Ethernet
ports, you need an Ethernet hub (available at computer retailers).
The Data Gateway package comes with one Ethernet cable (the connectors look like wide
telephone connectors); you can purchase more cables if necessary at a computer retailer. If
you are connecng the Data Gateway directly to a computer, or to an Ethernet hub with a
cross-over switch, ask for Category 6 (CAT6) straight-through cable. CAT6 cable is required
for best Ethernet performance. Regular CAT5 or CAT5e cable may not allow full-speed
Ethernet operaon.
Wireless
Wireless access lets you connect addional (wireless-capable) devices to Data Gateway. The
802.11 wireless LAN standard allows one or more computers to access the DG6450 using a
wireless (radio) signal. These connecons are in addion to the connecons supported via
Ethernet.
Wireless connecons are easier to install than standard Ethernet connecons. However,
wireless connecons are slightly less secure, increasing the chances that unauthorized users
could “eavesdrop” on connecons between the router and the connected device.
Note:
You can use the wireless connecon if your computer has a built-in or
aermarket plug-in wireless adapter. To learn more about which wireless hardware
works best with your computer, see your computer dealer.
Chapter 2: Get started
Touchstone DG6450 Data Gateway User Guide DRAFT Revision 2.5 13
To Next Page
Loading...
