CommScope Touchstone DG6450 User Manual

Connect the Data Gateway
1. Connect one end of the coax cable to the cable outlet or splier, and the other end to
the Data Gateway’s Cable connector (4). Tighten the connecons by hand, then ghten
an addional 1/8 turn with a wrench.
Note: For best performance, use high-quality coax cable and minimize or
eliminate spliers between the cable jack and the Data Gateway. If you are using
MoCA for your home network, MoCA lters must be installed on any legacy client
devices. Your service provider will install these lters for you.
2. Insert the plug from the power cord into the Power connector on the back of the Data
Gateway (8) and insert the power cord into a convenient AC outlet.
3. Connect one end of the Ethernet cable to any Ethernet port on the back of the Data
Gateway, and the other end to the Ethernet port on a computer or other client device.
Note:
Use the Ethernet cable included in the Data Gateway package.
Congure your wireless connecon
The DG6450 ships with wireless LAN security enabled by default. See the security label on
your product for the factory security sengs.
Chapter 2: Get started
Touchstone DG6450 Data Gateway User Guide DRAFT Revision 2.5 18

CommScope Touchstone DG6450 Specifications

General

Brand	CommScope
Model	Touchstone DG6450
Category	Gateway
Language	English