Safety information General information
2
General infor mation
Safety information
Power connection regulations
Please note the connection conditions specified by your
local electrical power supply company and the VDE
regulations.
Your heating control system may be installed and serviced
only by appropriately authorized specialists.
E If the system is not installed properly, there is a risk of
fatal or severe personal injury.
Warranty conditions
If the system is not installed, commissioned, serviced and
repaired properly, it will render the manufacturer's warranty
null and void.
Important text
! Important information is highlighted with an
exclamation mark.
E This attention symbol indicates dangerous situations.
Installation
Information on installation and starting the equipment up
as well as a connection diagram are provided in Part 3 of
this manual.
Description
Declaration of conformity
This device corresponds to the requirements of the
relevant guidelines and standards, if the corresponding
installation regulations and the manufacturer’s instructions
are complied with
Function
The controller enables setting and measuring values to be
entered and displayed for the heating system in the user's
living room.
This means that the heating system can be
monitored and optimized constantly. Use of this controller
also enables the room temperature to be regulated and
displayed directly.
! The following information only applies when the
boiler type connected can send and receive the
necessary data on the BUS. Dotted lines, for
example, appear in the display for data which is not
available.
To Next Page
Loading...
Need help?
General