>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
CAUTION
When removing or inserting cables with ZIF connectors, do not pull, twist, or
apply tension to cables.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
NOTE: The ZIF connectors in this product have mechanical latches that either
slide forward and lift up or slide up to open. Be sure the latches on the
ZIF connectors are opened before attempting to remove the cable.
4. Carefully disconnect the video board cable from the ZIF connector
(Figure 5-21).
5. Carefully disconnect two display inverter board cables (Figure 5-21).
6. Remove the display assembly and the display shield (Figure 5-21).
To replace the display assembly, reverse the steps in the above
illustrations.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
CAUTION
Do not clean the display screen with soap or isopropyl alcohol. Gently wipe
the display screen with a clean, low lint cloth, moistened with water.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Backlight Assembly
To remove the backlight assembly, complete the following steps:
1. Remove the keyboard (Section 5.5).
2. Remove the front bezel (Section 5.14).
3. Remove the display assembly (Section 5.14).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
CAUTION
Before touching the display assembly, be sure you are discharged of static
electricity by touching a grounded metal object.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
To Next Page
Loading...
Need help?
General