6. To replace the bezel, reverse the previous steps.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION <<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
The unit can become top-heavy when pressure is applied while replacing the
bezel. Supporting the unit with your hands will prevent it from falling
over.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Removing the Display Enclosure Latches and Springs
To remove the display enclosure latches and springs from either side of the
display enclosure, follow these steps:
1. Turn the computer off and remove all external devices, including the
battery pack and the AC Adapter. Remove the diskette and PC Card, if
installed (Section 5.3).
2. Open the computer.
3. Remove the display bezel. Refer to "Removing and Replacing the Display
Bezel" in this section.
4. Hold the bottom of the latch near the spring. Flex the hook end of the
display latch away from the display enclosure [1] (Figure 5-73).
5. Pull the display latch from the top, then out of the display enclosure
[2] (Figure 5-73).
To Next Page
Loading...
Need help?
General