Recommended Action: Replace the system board.
---------------------------------------------------------------------------
Message: 102 System Board Failure
Beeps: None (Beeps can be disabled by the user from the
Computer Setup utility.
Probable Cause: DMA register read/write test failed
Recommended Action: Replace the system board.
---------------------------------------------------------------------------
Message: 102 System Board Failure
Beeps: None (Beeps can be disabled by the user from the
Computer Setup utility.
Probable Cause: Protected mode test failed enabling/disabling A20 or
entering/existing protected mode
Recommended Action: Replace the system board.
---------------------------------------------------------------------------
Message: 102 System Board Failure
Beeps: None (Beeps can be disabled by the user from the
Computer Setup utility.
Probable Cause: Failed entering protected mode for memory test
Recommended Action: Replace the system board.
---------------------------------------------------------------------------
Message: 102 System Board Failure
Beeps: None (Beeps can be disabled by the user from the
Computer Setup utility.
Probable Cause: Test of timer zero interrupt failed (no interrupt
occurred)
Recommended Action: Replace the system board.
---------------------------------------------------------------------------
Message: 162 System Options Not Set
Beeps: 2 Short (Beeps can be disabled by the user from the
Computer Setup utility.
Probable Cause: Configuration incorrect
Recommended Action: Run Computer Setup.
---------------------------------------------------------------------------
Message: 162 System Options Not Set
Beeps: 2 Short (Beeps can be disabled by the user from the
Computer Setup utility.
Probable Cause: CMOS reflects that an invalid configuration has been
set
Recommended Action: Run Computer Setup.
---------------------------------------------------------------------------
To Next Page
Loading...
