Hardware Reference Guide 2–5
Working with the MultiBay
Inserting a Drive into the MultiBay
✎
If the personal computer did not ship with a MultiBay drive, there will
be a drive blank in the MultiBay. Refer to “Removing a Drive from
the MultiBay” on page 2-6 for instructions on removing the drive
blank.
1. Exit all software applications, shut down the operating system
software, and turn off the personal computer if you are inserting
or removing a hard drive.
2. Remove any removable media, such as a compact disc, from the
drive.
3. With the top of the drive facing up (or left, when the personal
computer is in the minitower position) and the drive connector
facing the personal computer, slide the drive into the MultiBay
and push firmly to ensure that the electrical connector is properly
seated.
sp-hrg.book Page 5 Thursday, December 13, 2001 9:14 AM
To Next Page
Loading...
Need help?
General