Compaq Presario 5700 Series - Fan

United States
STORE | PRODUCTS | SERVICES | SUPPORT | CONTACT US | SEARCH
Maintenance & Service Guide
Presario 5700 Series Personal Computers
Models: 5710, 5711, 5712, 5714, 5715, 5716, 5717, 5718, 5721,
5722, 5724, 5726, 5728, 5733, 5735, 5736, 5738, 5745 and 5746
MSG Index | Home | Preface | Product Description | Troubleshooting | Illustrated Parts |
Removal & Replacement | Jumpers & Switches | Specifications | Connector Pins
Removal and Replacement
Fan
Disassembly
Sequence
Chassis
Mass Storage Devices
Button Board
Front I/O Cable
Creativity Action Center
Fan
Option Card Retainer
Graphics Board
Fax/Modem
Networking Interface Card
Memory
Processor
Processor Retention Clips
Removal
1.
Perform the preparation for
disassembly procedures.
2.
Remove the Chassis.
3. Disconnect fan cable from the system
board.
4. Slide tabs out of the slots on both sides
of baffle and lift baffle up (baffle not
shown).
5. Remove four push pins on the back of
the chassis at the corners of the fan
grid. (Note: Use needle nose pliers or
similar tool to remove push pins.)
6. Pull fan straight out.
Replacement
To replace the fan, reverse the removal
procedure.
Compaq.com - Compaq Presario Maintenance and Service Guide - 5700 Series
http://www.compaq.com/athome/support/msgs/5700/remfan.html (1 of 2) [1/10/2002 11:55:44 AM]