Removal and Replacement Procedures
Maintenance and Service Guide 5–39
✎
The wireless antenna transceivers and cables are available in
the Wireless Antenna Kit, spare part number 410118-001.
26. If it is necessary to replace the wireless antenna transceivers
and cables, remove the Phillips PM2.5×5.0 screws 1 that
secure the wireless antenna transceivers to the display
enclosure.
27. Release the retention tabs 2 built in to the display enclosure
lining that secure the wireless antenna cables to the display
enclosure.
28. Detach the wireless antenna transceivers 3 from the display
enclosure.
29. Remove the wireless antenna transceivers and cables 4.
Removing the Wireless Antenna Transceivers and Cables
Reverse the above procedure to reassemble and install the
display assembly.
To Next Page
Loading...
