Removal and Replacement Procedures
Maintenance and Service Guide 5–69
4. Turn the system board right-side up with the expansion port 2
docking connector toward you.
5. Disconnect the fan cable 1 from the system board.
6. Remove the following screws:
2 One silver Phillips PM2.5×4.0 screw that secures the
expansion port 2 bracket and fan assembly to the system
board
3 Two slotted M1.5×9.0 screws on each side of the
expansion port 2 connector that secure the expansion port
bracket and fan assembly to the system board
4 Two Phillips PM3.0×6.0 screws on each side of the
external monitor connector that secure the fan assembly
to the system board
Removing the Fan Assembly Screws, Part 2
To Next Page
Loading...
