MODEL 2200
www.comtecltd.com For Kasco Corp use only.
9
If The Dies Do Not Close Fully.
Carry out the following steps:
1. Switch Power Off
2. Measure the distance from the bottom edge of the rectangular travel
plate which supports the bottom die half (also known as a travel plate) to
the top edge of the flange plate directly below the middle of the travel plate
(See Figure 7). The factory sets this distance to 2-3/4 inches (70 mm). The
distance can be safely reduced to 2-1/4 (57 mm) inches if needed.
3. If the measured distance is less than 2-3/4 inches (70 mm), adjust the
cylinder ram. The cylinder ram is located underneath the rectangular travel
plate. Release tension on lock nut at top of cylinder ram under the travel
plate. Take care to place wrenches only on the wrench-flat on top of ram
and hex surface of lock nut. Rotate hydraulic ram clockwise two full turns;
retighten lock nut.
4. Check Closing of Dies. Repeat this procedure if the dies still do not
close properly.
Figure 7 Model 2200 Press
To Next Page
Loading...