MNC-0500-026 31 of 32 Revision G
Amplifier Communication and Protocol, Rabbit CPU
Waveguide Switch Control
Command Byte: ‘U’
Format:
‘U3’ Activate override mode and switch in Amplifier switch 2, or set
switch 2 to position ‘A’ in 1-for-2 mode.
‘U2’ Activate override mode and switch in other Amplifier switch 2, or set
switch 2 to position ‘B’ in 1-for-2-mode.
‘U1’ Activate override mode and switch in Amplifier switch 1, or set
switch 1 to position ‘A’ in 1-for-2 mode.
‘U0’ Activate override mode and switch in other Amplifier switch 1, or set
switch 1 to position ‘B’ in 1-for-2 mode.
‘UM’ Activate override mode.
‘UA’ Terminate override mode, activating automatic mode.
Notes: When sending a ‘U3’, ‘U2’, ‘U1’ or ‘U0’ command, also send
a ‘UM’ command to the other amplifier to prevent unwanted automatic-mode
switches.
Compatibility: For Redundant ODUs only
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
To Next Page
Loading...