MNC-0300-036 21 of 26 Revision E
Unpacking and Installation
Figure 14, Waveguide SW1 RF Inhibit
A/B AMP Select
Refer to Figure 15. The Amplifier A/B select is an Opto isolator input.
When the input at J6-R is grounded, amplifier address B is selected.
Otherwise, amplifier address A is selected.
Figure 15, A/B Amplifier Select Diagram
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
To Next Page
Loading...