To Next PageTo Next Page
Need help?Do you have a question about the Comtech Xicom Technology XTD-750K and is the answer not in the manual?
General| Brand | Comtech Xicom Technology |
|---|---|
| Model | XTD-750K |
| Category | Amplifier |
| Language | English |
Describes safety information pertaining to Xicom Technology products, including warnings, cautions, and notes.
Explains the use of warnings, cautions, and notes to alert users to safety or performance conditions.
Details specific warnings and precautions related to high voltage hazards when operating the amplifier.
Provides warnings and precautions to be taken when using a ladder for maintenance or operation.
Warns about high power microwave radiation and necessary precautions before operation.
Covers power and interface connections, including prime power and M&C connectors.
Details the M&C interface for external control, including its features and connector type.
Details configuration options for single thread, redundant 1:1, and load switching.
Provides another level of switching, allowing maintenance on both amplifiers simultaneously.
Describes a configuration used as Redundant 1:1 or Power Combined Redundant System.
Outlines the procedure to ensure proper amplifier operation before the first turn-on.
Details the fault mode, triggered by detrimental conditions or safety issues, indicated by a red status LED.
Details the communication protocol used for amplifier control.
Lists and explains the available commands and queries for amplifier control.
Lists and details the various queries that can be sent to the amplifier.
Describes the advanced query feature for custom polling sequences and measurements.
Covers miscellaneous setup options for the amplifier, including linearization and configuration.
Provides a step-by-step procedure to update the HPA firmware using Rfu.exe.
Provides procedures for maintenance tasks, including lower deck inspection.
Procedure to remove, inspect, and clean the lower deck cover.
Details the process for obtaining authorization before returning equipment for service.
Instructs users to obtain an RMA Number before returning equipment for service.
Details the electrical characteristics and performance parameters of the HPA.
Describes local and remote control functions of the HPA.
Specifies important mechanical details of the product.
Details the non-operating and operating environmental conditions.
Outlines requirements for Acceptance Test Procedure (ATP) and First Article Test (FAT).
Provides procedures for setting up and operating the HPA Control Utility for TWTA operation.
Provides procedures for setting up and operating the HPA Control Utility for SSPA operation.
Explains ODU amplifiers configured for redundant operation without external controllers.
Explains how to enable automatic switching for redundant operation.
