MNC-0500-026 11 of 32 Revision G
Amplifier Communication and Protocol, Rabbit CPU
Commands and Queries
Firmware Information
The following firmware revision is baseline:
TWT Amplifier 1.00
All commands and queries listed herein are compatible with baseline firmware
except where noted.
Note
Certain commands and queries require that special options be present
in your unit(s). For example, an amplifier without an attenuator will
reject command ‘C’: “Set Attenuator”. In the Commands and Queries
in this section, compatibility issues are noted when relevant.
,List of Amplifier Queries provides the operators and technicians a list of the
amplifier queries and pages available for use.
,List of Amplifier Commands provides the operators and technicians a list
of the amplifier commands and pages available for use.
Table 1-6 List of Amplifier Queries
Query Page
Advanced Query Advanced Query
Alarm Condition Alarm Condition
Attenuator Counts Attenuator Counts
Current Screen Current Screen
Fault History Fault History
Fault Status Fault Status
Get Serial Configuration Get Serial Configuration
ID/Version ID/Version
Query Frequency Query Frequency
Power in dBW Power in dBW
Power in Watts Power in Watts
Miscellaneous Setup Miscellaneous Setup
Summary Status Summary Status
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
To Next Page
Loading...