MNC-0300-036 26 of 26 Revision E
Unpacking and Installation
7. For High Voltage to be applied place the HV ON switch in the ON
position.
8. If a fault occurs the LED will turn red. To reset the fault press the HV
switch to the RESET position (all the way down).
9. To control the HPA with a remote controller place the High Voltage
switch in the OFF position and place the LOCAL/REMOTE switch in
the REMOTE position.
EAR EXPORT CONTROLLED: The information contained in this Manual refers or relates to a product that is subject
to the U.S. Export Administration Regulations (EAR). Transfer of data herein by any means to a Foreign Person,
whether in the U.S. or abroad, may require an export license from the U.S. Department of Commerce.
To Next Page
Loading...