5. Feeding systems / Capacities
Depending on the application a different feeding system might be needed.
Use the following table to determine roughly the best system for the application. For more detailed information
please contact a Conair representative.
Feeding system Pellet
materials
Regrind/hard-to-
flow materials
Accuracy
Feeding capacity
†
Gram/sec.
Feeding capacity
†
Kg/hour
GLX YES No ++ 0.01 to 1.1 0.05 to 4.1
GX YES No + 0.1 to 5.0 0.5 to 12.6
HX
‡
NO No ++ 0.007 to 0.4 0.03 to 1.3
A-20LT
YES No +/- 0.4 to 14.0 1.3 to 50.4
A-20HT*
YES YES +/- 0.4 to 14.0 1.3 to 50.4
A-30HT* YES YES +/- 1.4 to 35.0
5.0 to 126.0
Note * Used for regrind and irregular shaped materials.
Note
†
Feed rates are based on materials with a bulk density of 35 lb/ft
3
.
Note
‡
For granular/free-flowing powder.
Which type of feeding system do I need with which throat adaptor?
The last 3 numbers are related to the length of the feeding system.
TYPE CODE FOR STANDARD THROAT
ADAPTOR
CODE FOR WATER-COOLED THROAT
ADAPTOR
GLX GLX GLXC
GX GX GXC
HX HX HXC
A20LT A20 A20C
A20HT A20HT A20HTC
NOTE: The “C” suffix for the water-cooled throat adapters symbolize a longer dispensing cylinder.
Front side view
GLX
Back side view
20LT
20HT
A30HT
GX
HX
6 Dual Feed TrueFeed Manual
To Next Page
Loading...