Conair TrueFeed - Appendix E: Truefeed Quality Checklist

APPENDIX E: TrueFeed Quality Checklist
Date of production : …………………
Conair order number : …………………
Controller serial number : …………………
Software version : …………………
Motor serial number : …………………
Unique ID code : …………………
Check original order with internal packing list
Ordercode
:
……………………………………………………………………
Cylinder check
 Fill in the type of cylinder………
 Fill in the cylinder length………mm
 Check for cylinder wrench
Steppe
r motor check
 Direction motor rotation from rear view (motor number side)
 Check if cable and connector are fastened well.
 Check sealing.
Hopper check
 Check hopper edges for blurs
 Check lid for sharp edges
 Check slide valve
 Check sealing ring
 Check sight glasses
Nec
kpiece check
 Check sight glass and the inside if everything is clean
 Check fitting of the feeding house
 Check curled knob length and fitting
Complete un
it check / Functional test at least 4 hours
 Perform loadcell calibration
 Perform a weight check with the 500gr reference weight
 Perform functional test with motor (200 rpm)
 Check timer and relay.
 Power cable/warning label
 Check input cable/ warning label
 Check appropriate users manual
 Check (optional) alarm flash light
 Check (optional) valve output
Automatic h
opper loader check (Optional)
 No automatic hopper loader supplied.
 ME hopper loader.
 MV hopper loader.
41 Dual Feed TrueFeed Manual