EasyManuals Logo

Concept2 SENTINEL S35 User Manual

Concept2 SENTINEL S35
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
5
5.1 SCREEN SENSOR
A “Screen Sensor” can be connected to the Sentinel as shown in the “Generic Connection Diagram”. When this is
integrated the system detects a drop in the fog density in the protected area and will re-trigger the Sentinel to
maintain the fog level. When fitted the Screen Sensor is connected to the Hold-off input pins and, consequently, it
prevents the use of a hold-off detector.
NB: It is critical that the Screen Sensor is installed in an area that receives the maximum fog coverage. It will not
operate correctly if this is not achieved. (See 4.2 generic connection diagram).
5.2 ENERGY SAVING MODE (ESM)
When ESM is selected and the alarm panel input to the Smoke Screen is “Unset” the Smoke Screen lowers its
running temperature to a standby level to reduce power consumption and cost. When the Smoke Screen receives an
‘Alarm Set’ input it automatically heats to its normal operating temperature. If the Smoke Screen is in ESM mode and
is activated as soon as the alarm is set, ie before it has heated to normal operating temperature, it will still
produce smoke but possibly for a shorter period than the set smoke time.
5.3 SERVICE MODE
Setting dip switch No 4 (see diagram under “Circuit Board Layout”) to “On” puts the Smoke Screen into “Service
Mode”. This setting prevents the Smoke Screen from making smoke whilst work is conducted with power applied.
To highlight that the Smoke Screen is in “Service Mode” the Tamper output is put into an alarm state.
FAILURE TO DISABLE SERVICE MODE WHEN NO LONGER REQUIRED WILL PREVENT THE SMOKE SCREEN
OPERATING.
5.4 TURBO SMOKE MODE
When “Turbo Smoke Mode” is set (see section under “Programming”) the Smoke Screen produces a high-volume
burst of smoke to provide rapid obscuration of a local, high value protected area. In “Normal Smoke Mode” the
Smoke Screen produces a short full-output burst followed by a lower output over a longer period.
17

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Concept2 SENTINEL S35 and is the answer not in the manual?

Concept2 SENTINEL S35 Specifications

General IconGeneral
BrandConcept2
ModelSENTINEL S35
CategoryPortable Generator
LanguageEnglish