EasyManuals Logo

Concept2 SENTINEL S35 User Manual

Concept2 SENTINEL S35
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
8
8.1 FAQ
Q
The Smoke Screen is indicating it is ready to operate but does not respond to a full alarm test.
A
Ensure “Service Mode” is disabled.
With power applied, and keeping clear of the smoke nozzle, disconnect the “Alarm”/”Trigger” and
“Hold-off” connection plugs from the PCB. If the Smoke Screen produces smoke there is a
mis-connection in the system wiring.
Q
The Smoke Screen is puffing out smoke whilst heating up.
A
This is the result of very small amounts of air and residual fluid in the heater block being changed into
an insignificant volume of smoke and can happen particularly after the Smoke Screen has been moved
about when cold, i.e. prior to installation or in the time after an activation.
28

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Concept2 SENTINEL S35 and is the answer not in the manual?

Concept2 SENTINEL S35 Specifications

General IconGeneral
BrandConcept2
ModelSENTINEL S35
CategoryPortable Generator
LanguageEnglish