● Wait until the smoke production has ceased. Do not try to enter the affected area as you will not be able to
see through the fog.
● Look for signs of forced entry. If you find any, or you believe that intruders are on the premises, call the
Police and wait for them to arrive. Take no further action.
● Where there are no signs of forced entry, open all external doors and wait for the fog to start clearing – this
may take 10 to 15 minutes. Keep watch for intruders that may have been screened by the fog.
● As visibility returns open more doors or windows to speed up the venting process.
● Check the fluid level for the Smoke Screen by checking the appropriate LEDs as described above. It is
recommended that the installer or Concept Smoke Screen are requested to service/replenish the Smoke
● Screen if there have been 2 or more activations of the Smoke Screen.
Please note that it is a requirement of the standards relating to security fogging devices the Smoke Screen is
serviced/replenished by an engineer certified by the manufacturer. If you are unsure, ask the engineer for his
certification ID card. It is recommended that the Smoke Screen is checked and the fluid changed annually by the
installer or Concept Smoke Screen. Always ensure that the Smoke Screen has sufficient fluid or it will not produce
smoke when needed. It is recommended that the installer or Concept Smoke Screen are requested to service/
replenish the Smoke Screen if there have been 2 or more activations of the Smoke Screen.
WARNING - only Smoke Screen fluid should be used as other smoke fluids may cause damage or noxious fumes.
To Next Page
Loading...
Need help?
General