EasyManuals Logo

Concept2 SENTINEL S35 User Manual

Concept2 SENTINEL S35
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
Setting Fluid Capacity. In the “Setting Fluid Capacity” display press Enter/Back to show the current fluid
capacity set. Use Up and Down buttons to move up and down to select 500ml, 1,000ml, 5,000ml or “Fluid
Sensor on”. Only “500ml” or “5,000ml” should be used on the S35; see the “Fluid Management” section for
information on the latter. Press Enter/Back to save the new setting and return to the higher level menu.
Press Function/Escape to return to the higher level menu without saving changes. The delivery Fluid
Capacity Setting is “500ml” on the Fluid Consumable models.
Setting Temperature. This is preset at manufacture and should only be altered by Concept Smoke Screen.
Setting Smoke Mode. In the “Setting Smoke Mode” display press Enter/Back to show the current smoke
mode set. Use the Up and Down buttons to move up and down to select “Turbo Mode” or “Normal Mode”.
Press Enter/Back to save the new setting and return to the higher level menu. Press Function/Escape to
return to the higher level menu without saving changes. The delivery Smoke Mode Setting is “Turbo Mode”.
Invert Trigger Mode. In the “Invert Trigger Mode” display press Enter/Back to show the current trigger mode
set. Use Up and Down buttons to move up and down to select “N/O Mode” (unit detects a normally open
circuit going closed to activate) or “N/C Mode” (unit detects a normally closed circuit going open to activate).
The Set, Trigger and Hold-off modes are always the same and changing this setting changes all 3 at once.
Press Enter/Back to save the new setting and return to the higher level menu. Press Function/Escape to
return to the higher level menu without saving changes. The delivery Trigger Mode Setting is “N/C Mode”.
Enable / Disable Battery. In the “Enable / Disable Battery” display press Enter/Back to show the current
battery setting. Use the Up and Down buttons to move up and down to select “Disable” or “Enable”. Press
Enter/Back to save the new setting and return to the higher level menu. Press Function/Escape to return to
the higher level menu without saving changes. The delivery Battery Setting is “Enable”. NB: the function of
the battery switch is described in the “Battery Management” Section.
Enable / Disable ESM (Energy Saving Mode). In the “Enable / Disable ESM” display press Enter/Back to
show the current ESM setting. Use the Up and Down buttons to move up and down to select “Disable” or
“Enable”. Press Enter/Back to save the new setting and return to the higher level menu. Press
Function/Escape to return to the higher level menu without saving changes. The delivery ESM Setting is
“Disable”.
Smoke Delay. In the “Smoke Delay” display press Enter/Back to show the current smoke delay set. Use the
Up and Down buttons to move up and down to select a time between 0 and 60 seconds in 1 second
intervals. Press Enter/Back to save the new setting and return to the higher level menu. The delivery Smoke
Delay Setting is “0 seconds”.
23

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Concept2 SENTINEL S35 and is the answer not in the manual?

Concept2 SENTINEL S35 Specifications

General IconGeneral
BrandConcept2
ModelSENTINEL S35
CategoryPortable Generator
LanguageEnglish