14
3.0 MAINTENANCE
3.1 Cleaning Information
3.1.1 Warnings, Precautions and Notes
1. Follow universal precautions for protective apparel when handling
and cleaning contaminated instruments.
2. Clean instruments within 30 minutes after use to minimize the potential of
blood and debris drying.
3. Never clean equipment in an ultrasonic cleaner.
4. Always disconnect the handpiece cord prior to cleaning.
5. Always detach accessories from equipment prior to cleaning.
6. Never clean handpieces with bleach, chlorine-based detergents, liquid or
chemical disinfectants, or any products containing sodium hydroxide
(such as, INSTRU-KLENZ or Buell Cleaner). These products degrade the
anodized aluminum coating and may result in reduced handpiece reliability.
7. For aluminum surfaces, a neutral-pH agent should be used. To prevent
corrosion, avoid contact with strong alkaline solutions (pH over 10.5) or
agents containing iodine or chlorine.
8. Prior to using a washer/sanitizer, consult product labeling on all washer/
sanitizer cleaning solutions for compatibility with aluminum. Use of a
washer/sanitizer may decrease the life expectancy of the handpiece.
Refer also to section “1.5 Warnings and Precautions”.
3.1.2 Manual Cleaning Instructions
1. Thoroughly scrub the handpiece and attachments with a clean, soft brush
dampened, not saturated, with a mild, pH-balanced detergent. Remove all
traces of blood, debris, and stains.
2. Place the suction control valve in the fully open position. Clean the suction
tube thoroughly with a cleaning brush until all debris is removed.
3. Using a low-velocity spray of water, spray into the collet. Ensure the collet
operates smoothly and that no debris is binding the internal mechanism of
the collet. Clean until all debris is removed.
!
To Next Page
Loading...
