Connective Peripherals ES-U Series - Page 53

USB to Serial Converters Manual
Version 2.0
Document Reference No.: CP_000032 Clearance No.: CP#022
Copyright © Connective Peripherals Pte Ltd 53
1.1
2011-01-24
Fixed issue with some links and updated all
links in document.
Set to revision 1.1 as this is a minor change
compared to 1.0.
Graham Brown
1.1
2011-01-25
Added “Twisted pair wires are required for each
signal pair.” in paragraph above each RS422
and RS485 wiring diagram.
Leave at v1.1, updated copyright date
Bob Recny
1.1
2011-01-26
released as Rev 1.1
Ian Dunn
1.2
2011-07-20
Added section for ES-U-2001-A and ES-U-
2101-A.
Updated driver screenshots to 2.08.14
Added ES-U-2001-A and ES-U-2101-A to the
lists of products throughout the document
Graham Brown
1.2
2011-08-11
Updated part numbers to ES-U-2001B and ES-
U-2101C as new units will be known as revision
B.
Graham Brown
1.2
2011-08-16
Standardised for all sections that only Rx
biasing should be used when an RS-485 half-
duplex network required biasing. Previously,
some sections recommended Tx only and
others recommended Rx only. Either would be
OK but updated this to keep it consistent
across all models.
Graham Brown
2011-08-16
Reviewed
Bob Recny
1.2
2011-08-23
Reviewed and minor mods made.
Released as Rev 1.2
Ian Dunn
1.3
2016-12-29
Re-branding to reflect the migration of the
product from EasySync to Connective
Peripherals name – logo change, disclaimer
changed, copyright changed, contact
information changed, all internal hyperlinks
changed.
L Subramanian
1.3
2019-03-20
Approved LCE
Assigned Clearance number
L Subramanian
1.4
2019-04-29
As advised by Alvin, updated the following part
numbers –
ES-U-2101B to ES-U-2101C
ES-U-3001-M to ES-U-3001-MB
ES-U-1101-M to ES-U-1101-MB
Updated Figure 10 – Driver Download from
FTDI Website
L Subramanian
1.4
2019-05-02
Reviewed – added comments
G Moore
2.0
2019-05-02
Created new version 2.0 for latest range of
converters for CP
G Brown