1. Before Using the Product
COM-1PD(USB)H
5
- Regarding “EMC Instruction Class A Notice”
This product has acquired the above-mentioned standard.
However, a sufficient margin may not be secured for the standard. In this case, use a ferrite core
(SEIWA E04SR301334 or a compatible product) for the COM cable (this product’s / connected
device’s side) or use a ferrite core (SEIWA E04SR170730A or a compatible product) for the USB
cable (PC side).
When attaching a ferrite core to the USB cable, just put the cable inside the case; when attaching a
ferrite core to the COM cable, coil it around once near the connector while leaving it open, and then
close it.
FCC PART 15Class A Notice
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in commercial
environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference at his own expense.
NOTE
Change or modifications not expressly approved the manufacturer can void the user's
authority to operate this equipment.
WARNING TO USER
To Next Page
Loading...